We use Optical Character Recognition (OCR) during our scanning and processing workflow to make the content of each page searchable. You can view the automatically generated text below as well as copy and paste individual pieces of text to quote in your own work.
Text recognition is never 100% accurate. Many parts of the scanned page may not be reflected in the OCR text output, including: images, page layout, certain fonts or handwriting.
iS4 SOUND MOTION PICTURES
plugs in the jack marked ECX50 and adjust the field rheostat marked "Bias Generator,, until you obtain a reading of 5.
Insert one of the instrument plugs in the jack marked ECX50, and adjust the field rheostat marked "Filament Generator" until you obtain a reading of 6.6. Insert one of the instrument plugs in the jack marked ILBXi and adjust the lamp rheostat so that a reading between 4.8 and 5.25 is obtained. Insert an instrument plug in the jack marked EB123X100 and adjust the field rheostat marked "Plate Generator" until it reads 5.
When a reading of 5 is obtained, as above, a plug inserted in the jack marked EB4-13 X 100 will give a reading of 10. Adjust the IP Back Tubes and the IP Front Tubes meter readings to 0.325 by means of the rheostats marked "Back Tubes IP Control" and "Front Tubes IP Control." The charging rate as indicated on the Charge-Discharge meter should be 4 to 7.5 amperes.
Throw the switches marked "LS" and the switch marked "Cones" on the sectionalizing panel to the "On" position, and the switch marked "Amp. No. 1" and "Amp. No. 2" to the correct position, depending upon the amplifier to be used. Plug the monitor loudspeaker in the "Monitor" plug of the amplifier to be used. Set the switches on the projectors marked " Fader" so that the projector that is not starting up is faded in. The projector faded in will be indicated by the red pilot lamp on the input panel.
III. SHOW OPERATION
A. Starting Projector: D. C. Motor Drive Set the switch marked "Speed Control" to "Normal." See to it that the dial at the end of the drive motor shaft is set to obtain the correct speed as given on the chart